Height Of Cut; Side Discharge Chute - Webb WER460SP Original Instructions Manual

HEIGHT OF CUT

To adjust the height of cut, the machine has been supplied with a single lever, located at the right rear wheel.
Adjusting the height of cut should only be undertaken when the engine is off, and the blade has come to a
complete standstill.
To adjust the height of cut, grab the height of cut lever and push it away from the gauge (1) and then lift or
lower the lever to the required height of cut (2).
Moving the lever forward will lower the height of cut (Min. 25mm). Moving the lever back, will raise the height
of cut (Max. 75mm)

SIDE DISCHARGE CHUTE

NOTE : When using the side discharge function. Remove the grass collector and plug the mulch plug into the
rear of the machine.
1. Unlock the side discharge cover and lift. Hook in the side discharge chute.
2. Allow the side discharge cover to secure onto the side discharge chute into position.
13