Huawei SmartAX MA5612 Maintenance Manual page 181

SmartAX MA5612 Multi-service Access Module
Maintenance Guide
l
Step 4 Check whether the fault is rectified.
l
l
Step 5 Run the pots circuit-test command to perform a
the affected port.
l
l
Step 6 Connect the phone to another port on the same board, and check whether the fault is rectified.
l
l
Step 7 Replace the voice service board and check whether the fault is rectified.
l
l
Step 8 Run the display boardframeid/slotid command to check whether the state of the DSP daughter
board is Normal.
l
l
Step 9 Run the display pstn state command to check whether CTPAdmState of the affected POTS
port is StartSvc.
l
l
Step 10 Run the undo endservice command to reactivate the service on the port, and check whether the
fault is rectified.
l
l
Step 11 Ensure that the media gateway (MG) interface is functional. Then, check whether the fault is
rectified.
Check whether the following conditions are met:
l Run the display if-h248 all command in H.248 mode or the display if-sip all command in SIP mode to
l Check whether the MG interface configuration on MA5612 is the same as that on the interconnected media
l Check whether the MA5612 communicates with the MGC properly.
l
l
Issue 01 (2012-07-25)
If Conclusion is not Normal, rectify the fault based on the displayed test conclusion. Then,
go to Step 4.
NOTE
For example, if Conclusion is Phone not connected, the phone is faulty or the line between the phone
and the device is not connected properly. In this case, replace the phone or ensure that the line is connected
properly.
If the fault is rectified, go to
If the fault persists, go to
If the results of all test items are Normal, the user port is functional. Go to
If the results of only some test items are Normal, the user port is faulty. Go to
If the fault is rectified, the original user port is faulty. Go to
If the fault persists, go to
If the fault is rectified, go to
If the fault persists, go to
If the state is Normal, go to
If the state is not Normal, go to
If CTPAdmState is StartSvc, go to
If CTPAdmState is not StartSvc, go to
If the fault is rectified, go to
If the fault persists, go to
NOTE
check whether the media gateway (MG) interface is working properly.
gateway controller (MGC).
If the fault is rectified, go to
If the fault persists, go to
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Troubleshooting Services Transmitted Through a GPON
Step 16.
Step 5.
8.3 POTS Subscriber Circuit Line Test
Step 7.
Step 16.
Step 8.
Step 9
Step 15
Step 11.
Step 10.
Step 16.
Step 11.
Step 16.
Step 12.
Step 8.
Step
Step 16.
Port
on
6.
172