Huawei SmartAX MA5612 Maintenance Manual page 151

SmartAX MA5612 Multi-service Access Module
Maintenance Guide
Issue 01 (2012-07-25)
Possibl Judgment Criterion
e
Cause
The If the following symptoms occur, the
progra fault is because the program ordered is
m not in the MVLAN to which the
ordered multicast user belongs.
is not in
l The ONU receives the report packet
the
and displays "match program fail".
MVLA
l The program ordered is not in the
N to
MVLAN to which the multicast
which
the
multica
st user
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Troubleshooting Services Transmitted Through a GPON
Troubleshooting Method
Choose one of the following
troubleshooting methods
according to the purchased service
type:
l Notify the user of ordering
l Perform the following steps to
another program because the
user has no permission to watch
the program (the program is
included in the MVLAN to
which the multicast user
belongs).
add the program to the
MVLAN to which the multicast
user belongs and then order the
program again.
a. Run the display igmp
config vlan command to
query Program match
mode of the program.
– If Program match
mode is enable, the
program is a static
program, which is
manually added.
– If Program match
mode is disable, the
program is a dynamic
program, which is
automatically generated
upon the ordering.
b. Add programs to the
MVLAN.
– To add a static program
to an MVLAN, run the
igmp program add
command.
– To add a dynamic
program to an MVLAN,
run the igmp match
group command to set
the IP address range of
program groups that can
be generated
Port
142