Huawei SmartAX MA5612 Maintenance Manual page 149

SmartAX MA5612 Multi-service Access Module
Maintenance Guide
Issue 01 (2012-07-25)
Possibl Judgment Criterion
e
Cause
The If one of the following symptoms
multica occurs, the fault is because the multicast
st user user does not have the permission to
does not watch the program.
have the
l The ONU receives the report packet
permiss
and displays "the user has no right".
ion to
l Run the display igmp user 100
watch
command to query the right profile
the
bound to the multicast user (assume
that the service port of the multicast
user is 100).
– If Bind profiles is 0, the user is
not bound to a right profile and
the user cannot order any
programs.
– If Bind profiles is equal to or
larger than 1, the user can watch
only the program to which the
user has the watch permission. In
this case, perform operations for
further check. In the queried
result, find the index (assume
that the index is 1) and name of
the program right profile bound
to the user and run the display
igmp profile profile-index 1
command to query the user
permission for ordering the
program.
– If the permission of a
program is forbidden or
idle, the user does not have
the permission to order the
program.
– If the permission of a
program is watch or
preview, the user can order
the program. Therefore, this
is not the cause for this fault.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Troubleshooting Services Transmitted Through a GPON
Troubleshooting Method
Choose one of the following
troubleshooting methods
according to the purchased service
type:
l If the user can watch all
l If the user can watch certain
programs without
authentication, perform the
following two operations:
a. In the BTV mode, run the
igmp user modify 100 no-
auth command to modify
the authentication mode of
the user to "no
authentication" (assume
that the multicast user index
is 100).
b. Order the program again.
programs with authentication,
notify the user of ordering
another program because the
user has no permission to watch
the program. The permission to
watch the program is watch or
preview.
Port
140