Bioness L300 GO Quick Start Manual

User's Reference Card
Putting On the L300 Go Functional Stimulation (FS) Cuff
1 While seated, slightly extend your lower leg.
Tilt the top of the L300 Go FS Cuff toward you, and then slide it up your leg until the locator
2
rests below the kneecap. Lower the bottom of the L300 Go FS Cuff onto your leg.
Hold the L300 Go FS Cuff in place with your thumb or other hand on the EPG cradle.
3
Pull the strap handle around the cradle.
Figure 4 shows the L300 Go FS Cuff correctly placed on the right leg.
4
1
Operating the L300 Go System
Status Indicator Light
Press the on/off button to turn on the EPG.
1
Select either gait or training mode:
2
• To select gait mode, press the
• To select training mode, press and hold the
The EPG will acknowledge the new mode with audio and tactile feedback. Press
the mode button again to activate training mode. To exit training mode, press
and hold the
If necessary, adjust the stimulation intensity level by pressing the
3
button.
Worldwide Corporate Office
Bioness Inc
25103 Rye Canyon Loop
Valencia, CA 91355
Telephone: 800.211.9136
Email: info@bioness.com
Website: www.bioness.com
2
Plus Button
Minus Button
Charging Port
mode button for 10 seconds.
European Authorized Representative:
Bioness Europe B.V.
Stationsweg 41
3331 LR Zwijndrecht, The Netherlands
Telephone: +31.78.625.6088
Email: international@nl.bioness.com
Website: www.bioness.com
3
Power Button
Stim Button
Battery Indicator Light
mode button briefly.
mode button for 10 seconds.
™
4
plus or minus