Firmware Display Of Wireless Pcb; Information On Additional Abus Products; Notes On Maintenance - Abus Secvest IP Installation And Operating Instructions Manual

19 Firmware display of wireless PCB

System
3x virtual zones
3x wireless zones
2x wireless outputs
1x relay output
4x transistor outputs
Operating units
Internal sirens
19. Firmware display of wireless PCB
When the alarm centre is connected to the power supply, a start routine is run
through the centre. First of all, LEDs light up briefly and then the firmware status of
the PCB is issued via dual coding.
Firmware of wireless PCB
First display
LED in first place from the
bottom lights up briefly
LED in second place from
the bottom lights up briefly
You can easily see the software status of the IP PCB via the web server.
"System Maintenance

20. Information on additional ABUS products

You can deal with any problems concerning the wireless range by using the repeater
function of the Secvest 2WAY wireless universal module (FU8210). Read the user
manual for the universal module.

21. Notes on maintenance

Set the alarm centre to learn mode when carrying out maintenance. You can then
open the alarm centre or teach wireless components (or change the battery) without
triggering a tamper alarm.
This is made using the web server: "System
Maximum number
Version 1
3x PIR IP network
cameras
3 zones with a total of 11
detectors (4/3/4
detectors per zone)
For any number of wireless sockets per output
To control wired components
To trigger diallers
Max. 3 parts, wireless remote operation, Secvest key or
additional door lock (any combination possible)
Any number
Second display
LED in fourth place from
the bottom lights up briefly
LED in second place from
the bottom lights up briefly
Firmware version"
Maintenance
77
Version 1
1x IP alarm module + 1x PIR
IP network camera
3 zones with a total of 10
detectors (3/3/4 detectors
per zone) + 1x external siren
Firmware status
1.8
2.2
Learn Mode ON"