Table of Contents
Advertisement
5) Secure the track
to the post by
closing the hook
handle while
pushing the hook
over the track
pin. The red
marks on the
hook handle
should no longer
be visible.
You should feel a slight tension when
closing the hook handle.
Repeat procedure until all 4 hooks are
secured.
Following figure shows a view of the track when
properly installed and locked in place.
CAUTION: Make sure the main hooks are
well engaged.
Step 3.
Track Width Adjustment
1) To adjust the track width, pull the inner track
away from the main outer track until the
desired width is achieved.
Inner Track
2) Trolley position should be as shown in
"Fig. 1 3". If not, make sure that inner track is
extended. Trolley will become free of its
transportation slot. If it does not, shake the
trolley lightly left and right to release it.
Trolley should move freely at this point.
NOTE: This step can also be done after
adjusting the height.
Assembling the EASYTRACK FS
Push
to lock
Fig. 1 2
Trolley
Fig. 1 3
Step 4.
Height Adjustment
Extending the Posts
1) Pull on the lower
portions of each
collar
handle located on
both sides of the
collar to release
the
mechanisms and
Fig. 1 1
allow the inside
section
post to extend
upwards.
When the clamping collars are in the open
position red marks are visible.
2) Position yourself
under the track
and gently push
upwards until the
desired height is
achieved.
CAUTION: NEVER extend the post to allow
the track to be in contact with the ceiling.
Always leave a clearance of at least 30 mm
(1 inch) above the track. This clearance is
necessary to allow retracting the post for
disassembling.
Levelling the Track
4) Ensure the track
is level. To level
the track, extend
both posts to
same length.
Make sure the
ruler in front of
the post is exiting
the post by same
lenght for both
posts.
Openned
Clamps
locking
locking
Red Marks
of
the
Fig. 1 4
Fig. 1 5
Fig. 1 6
9
Hide quick links:
Advertisement
Table of Contents
