Specifications; Power Requirement - National Instruments SCC-FT01 User Manual

Connecting the Screw Terminals

Specifications

Analog

Power Requirement

Physical
Safety
SCC-FT01 Feedthrough Module User Guide
The pads next to connector J1 connect to each input of the screw terminal
connector. Use these pads to connect the external signals to the circuitry
you added in the breadboard area. The numbers next to each hole
correspond to the screw terminal numbers. Space is available on the
SCC-FT01 prototyping module label for custom signal names.
For information about how to configure the SCC-FT01 module using
NI-DAQmx, refer to the SCC Quick Start Guide.
These ratings are typical at 25 °C unless otherwise stated.
Number of input channels.......................1 DIFF or 2 SE (when plugged
Number of output channels.....................1 (when plugged into an
No power required (if unmodified)
Dimensions .............................................8.89 cm × 2.92 cm × 1.85 cm
I/O connectors.........................................20-pin right-angle male connector
Screw terminal ........................................28 to 16 AWG
This product is designed to meet the requirements of the following
standards of safety for electrical equipment for measurement, control,
and laboratory use:
• IEC 61010-1, EN 61010-1
• UL 3111-1, UL 61010B-1
• CAN/CSA C22.2 No. 1010.1
into an AI socket on the SC-2345)
AO socket on the SC-2345)
(3.50 in. × 1.15 in. × 0.73 in.)
6-pin screw terminal system
10 ni.com