Single Sided; Framing - Heat&Glo FOUNDATION Series Installation And Operating Manual

SINGLE SIDED


Figure 4
IMPORTANT: FIREPLACE IS NOT LOAD-BEARING.
B
SINGLE SIDED
Model # A
55-3/4
FDN-4-SS
[1,416]
67-3/4
FDN-5-SS
[1,721]
79-3/4
FDN-6-SS
[2,026]
91-3/4
FDN-7-SS
[2,330]
Heat & Glo • FDN-4-SS, FDN-5-SS, FDN-6-SS, FDN-7-SS Installation Manual • 16400-9800 Rev. H • 11/19

4 - FRAMING

MINIMUM NON-COMBUSTIBLE ZONE
A
IMPORTANT FRAMING NOTES:
FRAMING SHOULD BE BUILT AFTER THE FIREPLACE IS INSTALLED OR EXTRA CLEARANCE MUST
B C
BE PLANNED FOR AT THE INTAKE COLLAR AND FOR THICKNESS OF MATERIALS USED.
56 25-1/32
FRAMING DIMENSIONS ASSUMING 1/2" [13] DRYWALL AND NON-COMBUSTIBLE BOARD USED.
[1,422] [636]
THESE DIMENSIONS REPRESENT THE FRAMING DIMENSIONS FOR COMBUSTIBLE MATERIAL.
56 25-1/32
[1,422] [636]
NON-COMBUSTIBLE FRAMING AND FINISHING MATERIALS MAY BE USED WITHIN THESE DIMENSIONS
56 25-1/32
RIGHT UP TO THE UNIT.
[1,422] [636]
NO COMBUSTIBLE MATERIAL WITHIN 6" [152] OF THE TOP OF THE FIREPLACE.
56 25-1/32
[1,422] [636] NO COMBUSTIBLE MATERIAL WITHIN 1" [25] OF THE SIDES AND BACK OF THE FIREPLACE.
COMBUSTIBLE MATERIAL SHALL NOT BE PLACED DIRECTLY ON THE FACE OF THE FIREPLACE, TOP
AND SIDES.
SEE SECTION 10 (FINISHING) FOR DETAILS REGARDING 1/2 INCH STANDOFFS.
STEEL SURFACE MAY BE COVERED WITH NON-COMBUSTIBLE FINISHING MATERIAL.
1" [25] CLEARANCE TO THE B-VENT MUST BE MAINTAINED.
COMBUSTIBLE OR NON-COMBUSTIBLE
BACKING MATERIAL (I.E. SHEETROCK)
OPEN AIR SPACE
6" [25]
1/2" Standoffs
C
11