Table of Contents
Advertisement
BEFORE STORING
CAUTION
•
If any time your lift truck is found to be
in need of repair, defective or in any way
unsafe, the condition should be reported
to the supervisor, and the truck should
be taken out of service until it has been
restored to safe operating condition.
•
Use caution to prevent electrical parts from
getting wet when washing the truck.
Before storing the lift truck, clean it thoroughly and
perform inspection using the following procedure:
•
Wipe away grease, oil, etc., adhering to the body
of the truck with shop rag. Use water, if needed.
•
While washing the truck, check the general
condition of the truck. Especially check the truck
body for dents or cracks, the tires for wear or
nails or stones in the tread.
•
Check the fuel level and add if necessary.
•
Check for leakage of hydraulic oil, engine oil, fuel
or cooling water.
Apply grease, where needed.
•
Check for looseness of the hub nuts and cylinder
•
piston rod joints.
•
Check the mast rollers to see that they rotate
smoothly.
Lift the forks up to the top position and lower to
•
the lower limit. Repeat this procedure to prime oil
into the lift cylinders.
DAILY STORAGE
Park the truck at a specified place and block the
•
wheels.
•
Place the shift lever(s) in neutral "N" and pull the
parking brake lever fully.
•
Shut down the engine and operate the load
handling levers several times slowly to remove
the residual pressure from the cylinders and
hoses.
•
Remove the starter key and keep it in a safe
place.
STORING
LONG-TERM STORAGE
Perform the following checks in addition to
"BEFORE STORING" and "DAILY STORAGE"
services.
Taking the rainy season into consideration, park
•
the truck at a higher and hard ground.
•
Remove the battery from the truck.
•
Even though the truck is parked indoors, if the
place is hot or humid, the battery should be kept
in a dry, cool place, and charged once a month.
Apply anti-rust to the exposed parts such as
•
cylinder rods and shafts that tend to rust.
•
Cover components which may be caught with
humidity, such as the air breather and air cleaner.
•
Put the truck in the operating state once a week
and start the engine. Warm it up sufficiently
before moving the truck a little back and forth.
•
Avoid parking on a soft ground such as an
asphalt ground in summer.
OPERATING AFTER LONG-TERM
STORAGE
•
Remove covers used to seal off moisture.
•
Remove antirust from the exposed parts.
•
Drain the crankcase,
converter , clean their inside and add new oil.
•
Drain foreign matter and water from the hydraulic
oil tank and fuel tank.
Remove the engine cylinder head cover and
•
lubricate the valves and rocker shafts. Check the
valves for proper operation.
•
Add cooling water to the specified level.
•
Charge the battery and mount it on the truck.
Connect the cables.
Perform pre-operational checks carefully.
•
•
Warm up the engine.
3-13
differential, and torque
Hide quick links:
Advertisement
Table of Contents
