Table of Contents
Advertisement
C240:
V2403:
6. Make sure there is no oil leak from the filter mounting
area. (Add engine oil to the specified level, start the
engine and run it at idle rpm for a while.)
NOTE
When removing the filter cartridge, engine oil might
spill over the floor. Put an oil receiving pan or cloth.
■ LUBRICATING LIFT CHAIN
Apply engine oil to the lift chains using an oiler or brush.
To allow oil to enter between each pin and link plate of
the lift chain, observe the following conditions:
•
Loosen the chain sufficiently.
•
After applying engine oil, move the mast up and down
at least 10 times.
NOTE
If your lift truck is used near a port or coastal area, the
lift chains might be damaged from salty breezes. After
a storm or typhoon, it is advisable to wash them with
water before lubricating in the above manner.
PERIODIC INSPECTION
about 1/4 of a turn
Tighten firmly by hand.
C240
4-34
Hide quick links:
Advertisement
Table of Contents
