Jeep Compass 2020 Owner's Manual page 383

1. Uncoil the Sealant Hose, and then remove the cap from
the fitting at the end of the hose.
2. Place the Tire Service Kit flat on the ground next to the
deflated tire.
3. Remove the cap from the valve stem, and then
screw the fitting at the end of the Sealant Hose
onto the valve stem.
4. Uncoil the power plug and insert the plug into
the vehicle's 12 Volt power outlet.
5. Uncoil the Hose and screw the fitting at the end
of the hose onto the valve stem.
6. Turn the Mode Select Knob and turn to the Air
Mode position.
7. Check the pressure in the tire by reading the Pressure
Gauge.
If tire pressure is less than 19 psi (1.3 Bar):
The tire is too badly damaged. Do not attempt to drive the
vehicle further. Call for assistance.
If the tire pressure is 19 psi (1.3 Bar) or higher:
1. Push the Power Button to turn on Tire Service
Kit and inflate the tire to the cold tire inflation
pressure found on the tire and loading informa-
tion label located in the driver-side door opening.
NOTE:
If the tire becomes over-inflated, push the Deflation Button
to reduce the tire pressure to the recommended inflation
pressure before continuing.
2. Disconnect the Tire Service Kit from the valve stem, rein-
stall the cap on the valve stem and unplug from 12 Volt
outlet.
3. Place the Tire Service Kit in its proper storage area in the
vehicle.
4. Have the tire inspected and repaired or replaced at the
earliest opportunity at an authorized dealer or tire service
center.
IN CASE OF EMERGENCY 381
6