Jeep Compass 2020 Owner's Manual page 232

230 SAFETY
8. If the child restraint has a top tether strap and the seating
position has a top tether anchorage, connect the tether
strap to the anchorage and tighten the tether strap. See the
section "Installing Child Restraints Using the Top Tether
Anchorage" for directions to attach a tether anchor.
9. Test that the child restraint is installed tightly by pulling
back and forth on the child seat at the belt path. It should
not move more than 1 inch (25.4 mm) in any direction.
Any seat belt system will loosen with time, so check the belt
occasionally, and pull it tight if necessary.
Installing Child Restraints Using The Top Tether
Anchorage:
WARNING!
Do not attach a tether strap for a rear-facing car seat to any
location in front of the car seat, including the seat frame or
a tether anchorage. Only attach the tether strap of a
rear-facing car seat to the tether anchorage that is
approved for that seating position, located behind the top
of the vehicle seat. See the section "Lower Anchors and
Tethers for CHildren (LATCH) Restraint System" for the
location of approved tether anchorages in your vehicle.