To Cancel; To Turn Off; To Resume - Jeep Compass 2020 Owner's Manual

To Cancel

The following conditions cancel the system:
• The brake pedal is applied.
• The CANC button is pushed.
• An Anti-Lock Brake System (ABS) event occurs.
• The gear selector is removed from the Drive position.
• The braking temperature exceeds normal range (over-
heated).
• The Electronic Stability Control/Traction Control System
(ESC/TCS) activates.
• The vehicle parking brake is applied.
• Driver seatbelt is unbuckled at low speeds.
• Driver door is opened at low speeds.
• The driver switches ESC to Full Off mode.
• Manual transmission is not in a forward gear, if equipped.
• Manual transmission is in NEUTRAL or clutch pressed
down for a fixed amount of time, if equipped.
• Manual transmission vehicle speed drops below 15 mph
(24 km/h), if equipped.

To Turn Off

The system will turn off and clear the set speed in memory if:
• The Adaptive Cruise Control (ACC) on/off button is
pushed.
• The Normal (Fixed Speed) Cruise Control on/off button is
pushed.
• The ignition is placed in the OFF position.
• You switch to Four-Wheel Drive Low.

To Resume

If there is a set speed in the memory, push the RES button
and then remove your foot from the accelerator pedal. The
instrument cluster display will show the last set speed.
WARNING!
The Resume function should only be used if traffic and
road conditions permit. Resuming a set speed that is too
high or too low for prevailing traffic and road conditions
could cause the vehicle to accelerate or decelerate too
sharply for safe operation. Failure to follow these
warnings can result in a collision and death or serious
personal injury.
STARTING AND OPERATING 279
5