Table of Contents
Advertisement
Facings, gather hood and vents
Facings, gather hood and vents
Face the product only after having completed the
Face the product only after having completed the
following steps:
following steps:
• •
connection of the product to the smoke outlet and
connection of the product to the smoke outlet and
air intake;
air intake;
• •
inspection of the product when hot;
inspection of the product when hot;
• •
check to verify whether the product is levelled.
check to verify whether the product is levelled.
The installer must implement all the installation good
The installer must implement all the installation good
practices and take all the necessary precautions
practices and take all the necessary precautions
against overheating and fi re.
against overheating and fi re.
In particular:
In particular:
• •
if a plinth is constructed beneath the hearth level,
if a plinth is constructed beneath the hearth level,
it must include a suitable slot for the passage of
it must include a suitable slot for the passage of
recirculation air from the room;
recirculation air from the room;
• •
if the Air Diffuser Kit is installed, it must be possible
if the Air Diffuser Kit is installed, it must be possible
to inspect or replace the fans;
to inspect or replace the fans;
• •
wooden parts must be protected with fi reproof
wooden parts must be protected with fi reproof
panels, which must not be placed against one
panels, which must not be placed against one
another but spaced at least 1 cm apart to enable air
another but spaced at least 1 cm apart to enable air
to fl ow and prevent heat build-up. The gather hood
to fl ow and prevent heat build-up. The gather hood
can be made with fi reproof panels, plasterboard
can be made with fi reproof panels, plasterboard
or gypsum slabs; during construction, the hot air
or gypsum slabs; during construction, the hot air
ducting kit must be mounted as described above.
ducting kit must be mounted as described above.
The interior of the gather hood should be aerated
The interior of the gather hood should be aerated
14
by exploiting the fl ow of air coming from below (the
by exploiting the fl ow of air coming from below (the
space between the door and mantel) which convective
space between the door and mantel) which convective
currents will cause to exit from the grille on top,
currents will cause to exit from the grille on top,
thus allowing heat recovery and preventing undue
thus allowing heat recovery and preventing undue
overheating.
overheating.
In addition to that mentioned above, take into account
In addition to that mentioned above, take into account
the
the regulations in force in the relevant country
concerning "insulation, fi nishes, facings and safety
"insulation, fi nishes, facings and safety
recommendations".
recommendations".
Vents
Vents
These must be strictly installed on the front: one
These must be strictly installed on the front: one
beneath and one above the fi replace's opening. The
beneath and one above the fi replace's opening. The
product is not supplied with.
product is not supplied with.
INSTALLATION
FRAME (OPTIONAL)
FRAME (OPTIONAL)
The inlet surround is an optional accessory.
It fi lls in the gap remaining between the fi rebox's
frame and the cladding itself.
•
If purchased, it is sold in a single item containing:
•
the frame itself (1)
•
n° 9 screws (2)
•
n° 5 nuts (3)
•
n° 3 fi xing corner elements (4)
To assemble it:
secure the brackets to the fi replace structure;
tighten the screws
tighten the nuts
•
1
3
2
2
4
Hide quick links:
Advertisement
Table of Contents
