EdilKamin WINDO2 75 Installation, Use And Maintenance Manual page 12

NATURAL CONVECTION CIRCULATION NATURAL CONVECTION CIRCULATION
PRIOR TO INSTALLING THE FACING MATERIAL, IT IS PRIOR TO INSTALLING THE FACING MATERIAL, IT IS
NECESSARY TO DECIDE WHETHER TO PURCHASE NECESSARY TO DECIDE WHETHER TO PURCHASE
AND INSTALL THE "AIR DIFFUSER KIT" FOR FORCED AND INSTALL THE "AIR DIFFUSER KIT" FOR FORCED
VENTILATION VENTILATION
The ambient air enters the structure through openings The ambient air enters the structure through openings
along the lower section of the fi replace casing along the lower section of the fi replace casing (1)
The openings on the fi replace casing are initially The openings on the fi replace casing are initially
closed and must be opened by removing the pre-cut closed and must be opened by removing the pre-cut
membranes to enable the ambient air to pass through membranes to enable the ambient air to pass through
them. them.
The ambient air heats up and rises by convection The ambient air heats up and rises by convection
along the air gap behind the hearth and emerges hot along the air gap behind the hearth and emerges hot
from the vents (2) from the vents (2) positioned on the casing's cover. positioned on the casing's cover.
The length of the ducting depends on the product's The length of the ducting depends on the product's
insulation and manner of use. insulation and manner of use.
It is essential to guarantee the return of
12
the air into the room where the fi replace is
installed by means of grills at the base of
the walls or gaps under the doors.
Micro-switch (M-only if the Air Diffuser Kit Micro-switch (M-
is installed).
The micro-switch located on the front, on the same
level as the hearth and visible after removing the front
panel switches the fans off when the door is opened.
To activate it, connect it electrically to the kit's fans.
INSTALLATION
(1)
M
2
1