Valcom PagePac Plus V-5323100 Manual page 18

0 to select 300 bps
1 to select 1200 bps
2 to select 2400 bps
3 to select 4800 bps
4 to select 9600 bps
5
to select 14400 bps
6 to select 19200 bps
Hear TRIPLE beeps.
3. To verify the status of this option, dial 2 3 and repeat step 2 above.
2 4 INHIBIT DIAL TONE DETECT
Supervision of the Station/Centrex Access mode is accomplished in 3 ways, by monitoring the loop current and
the audio signal (including dial tone), and a forced disconnect timer. This option (only applicable in the station
access mode) enables you to defeat the dial tone detect function in order to send a tone via the Telephone
Interface to the output.
1. Dial 2 4 to select this option.
Hear a DOUBLE beep.
2. Dial 0 to Enable, or 1 to Inhibit.
Hear TRIPLE beeps.
3. To verify the condition (OFF/ON) of the Dial Tone Detect option, dial 2 5 and repeat step 2
above.
3 0 SET CONNECT PASSWORD
This feature will not become active until the first time you enter a password, via the programming mode. The
factory default is NO password. The Connect password operates as a security block into the paging system,
restricting paging access to authorized users.
Note: You may want to use a short Connect password (2 or 3 digits only) for ease of use.
1. Dial 3 0 to select this option.
Hear a DOUBLE beep.
2. Enter the Password you wish to use (up to 6 digits). If the password has fewer than 6 digits, enter the # to
terminate the string.
Note: For example, 123456 is a valid password entry. 123# is also a valid password entry, resulting in
the password 123.
If you already have entered a password and want to remove it (to have NO password), just enter the # alone.
Hear TRIPLE beeps.
To verify that the new Connect password has been established, dial 3 1 and repeat step 2 above.
3 2 SET PROGRAMMING PASSWORD
Establishing a Programming password will restrict access to the programming mode of the PagePac Plus
paging system. It is recommended that access to programming be restricted to the System Administrator,
Telecommunications Manager, or other selected users.
Note: Your Connect and Programming passwords should not be the same. If this feature is active and
the system has been accessed via the telephone interface, then after the first digit of your Programming
password is pressed, the dial tone will stop and will not be returned until the correct password is
entered or until the user hangs up and re-enters the system.
This feature will become active once any programming password has been entered via the programming mode.
You are not required to establish such a password. The factory set default programming password is * *.
1. Dial 3 2 to select this option. Hear a DOUBLE beep.
2. Enter the Password you wish to use (up to 6 digits). If the password has fewer than 6 digits,
enter the # to terminate the string.
NOTE: For example, 234567 is a valid password entry. 234# is also a valid password entry, resulting in
the password 234.
18