Valcom PagePac V-5335100 Quick Start Manual

PagePac
by
INTRODUCTION
The Zone Expansion Unit (Z.E.U.) connects up to
16 zones of audio output (including talkback),
contact closure outputs or inputs.
SPECIFICATIONS
FEATURES
• Provides same features as PP+ Controller
• Maximum of 3 Z.E.U.s per Controller
Power Requirements
• Power from the PP+ Controller through the
interconnect cable
Dimensions/Weight
• 16.00"W x 1.75"H x 6.875"D
(40.64cm x 4.45cm x 17.46cm)
• 3.0 lbs (1.35 kg)
Environment
• Temperature:0 to 40°C (32 to 104°F)
• Humidity:
Locate in an area free of excess moisture, corro-
sive gases, dust and chemicals.
INSTALLATION
MOUNTING
NOTE: When installing the Zone Expansion Unit,
leave at least four inches of space above and
below for proper ventilation.
Installing the paging equipment in a ventilated
room where there is easy access to speaker
cabling (preferably in the telephone equipment
room). Disconnect all power before installing
equipment.
1. Mount the Zone Expansion Unit(s)(Z.E.U.) to
either a wall, cabinet or a rack (below the con-
troller).
Technical Manuals Online! - http://www.tech-man.com Technical Manuals Online! - http://www.tech-man.com
®
PAGEPAC PLUS ZONE EXPANSION UNIT
(see Table 2)
5 to 95%
firealarmresources.com
V-5335100
2. Connect 8-pin Molex from Controller to first
Z.E.U., and next Z.E.U's, if used.
NOTE: Up to 3 Z.E.U.s can be used, providing up
to 56 paging and/or control zones.
3. Set DIP switches on each Z.E.U.(s).
4. Set the Zone Option switches on the
Controller and Z.E.U.(s).
NOTE: For each zone used, no matter what its
function, this switch needs to be set to one of
three settings for proper zone operation before
applying power to the system.
The Controller has eight switches for zones 1-8.
Each subsequent Z.E.U. has switches for zones
9-24, 25-40, 41-56.
Refer to the Zone Map and Zone Configuration
Tables filled out during facility paging system
design. You can find these in the PagePac® Sys-
tem Installation and Configuration Guide.
5. Locate and mount all speakers in accordance
with the floor plan drawing for this installation.
6. Connect each speaker to the appropriate
Home Run or Speaker-to-Speaker wiring
scheme as shown on the floor plan.
NOTE: Adjust all speakers per volume and power
requirements as noted on floor plan, during or
after installation. Figures 7 and 8 show wiring
methods using local and zone connector blocks,
and contact closure zone applications.
1
Issue 1
947187