Siemens SITRANS F Series Function Manual page 31

Index Parameter name
53 View_4
62 PARAMS_1_REG‐
ISTER
63 PARAMS_1_DATA
64 PARAMS_2_REG‐
ISTER
65 PARAMS_2_DATA
68 LIST_IDENT_NUM_
SUP
69 CURRENT_AC‐
CESS_LEVEL
70 DEFAULT_AC‐
CESS_LEVEL
71 LOGIN_USER
72 LOGIN_EXPERT
FCT030 Profibus (From firmware 4.0)
Function Manual, 06/2018, A5E39931906-AB
Data type Access
[size]
Read /
write
Read /
write
Read /
write
Read /
write
Read /
write
Unsigned16 Read only
Unsigned8 Read only
Unsigned8 Read /
write
Unsigned16 Read /
write
Unsigned16 Read /
write
Annotation
Parameter to read and write the following block parameters
at once:
● TARGET_MODE
● ALARM_DELAY
● UPDATE_EVENT_MODE
● LINK_NE107_COMMON
32 bytes to define 16 MODBUS registers that are accessible
all with one read and/or write request to PARAMS_1_DATA
64 byte data field for parameters specified by PAR‐
AMS_1_REGISTER
64 bytes to define 32 MODBUS registers that are accessible
all with one read and/or write request to PARAMS_2_DATA
128 byte data field for parameters specified by PAR‐
AMS_2_REGISTER
This parameter is intentionally the double size of PAR‐
AMS_1_DATA. Some PROFIBUS components might still
have a frame length limit that does not allow the access of
larger data units. For these components PARAMS_1_DATA
can be used.
Provides information which ident numbers are supported by
the device. This includes the profile GSD files.
Current access level of the acyclic connection. The access
level is handled for each acyclic connection.
2: Read only
3: User
4: Expert
Initial access level for an acyclic connection. See also access
control
2: Read only
3: User
Input of the end user PIN to change the current AC‐
CESS_LEVEL of the acyclic connection.
Reading this parameter indicates if User privilege is granted
(1) or not (0).
Input of the service user PIN to change the current AC‐
CESS_LEVEL of the acyclic connection
Reading this parameter indicates if User privilege is granted
(1) or not (0).
Communication
2.10 Acyclic communication
31