Install Bottom Cover - Ariens Professional Sno-Thro Series Service Manual

7. Remove hardware retaining bottom cover to frame
and remove cover. See Figure 21.
Figure 21

Install Bottom Cover

1. Reinstall bottom cover and secure with two tapping
screws and four hex bolts.
2.
Models 926068, 926070, 926334, 926336, 926337:
advance to step 6.
Models 926060, 926069, 926338
See Figure 22.
3. Reposition height adjuster stop against height adjuster
bracket. Align slot with top hole in height adjuster
bracket.
IMPORTANT: Align one of the three notches in height
adjuster with lock finger to hold adjuster position.
CAUTION: AVOID INJURY. Height adjuster is
unsecured until hardware is reinstalled. Be
careful not to bump adjuster from position on
lock finger. Keep hands away from pinch points.
4. Reinstall carriage bolts through height adjuster
bracket and reinstall spacers onto bolts.
5. Reinstall height adjuster plate and secure with three
flange nuts.
All Models
6. Return unit to operating position.
EN – 16
Figure 22