Ariens Professional Sno-Thro Series Service Manual page 23

Attachment Clutch Disengaged / Brake Engaged
1
1. Brake Pad
2. Brake Roller
Attachment Clutch Engaged / Brake Disengaged
4. Reinstall attachment drive belts. See Install
Attachment Drive Belts on page 16.
2
Figure 36
Figure 37
WARNING: AVOID INJURY. Before placing unit
in service position, drain fuel from tank and fuel
system. See Draining Fuel System on page 7.
Make sure unit is secure and will not tip.
5. Place unit in service position and remove bottom
cover. See Service Position on page 7 and Remove
Bottom Cover on page 14.
See Figure 38.
6. Check attachment brake:
• Brake must contact attachment belt when
attachment clutch is disengaged.
• Brake must be more than 1.6 mm (1/16") away from
attachment belt when attachment clutch is engaged.
7. Reinstall bottom cover and secure with two tapping
screws and four hex bolts.
8. Return unit to operating position.
9. Reconnect spark plug wire and fill fuel tank.
IMPORTANT: Check all adjustments after first use.
WARNING: AVOID INJURY. Auger / impeller
must stop within 5 seconds when attachment
clutch lever is released.
EN – 22
Figure 38