Install Bottom Cover; Attachment Drive Belt Replacement; Remove Attachment Drive Belts; Install Attachment Drive Belts - Ariens Sno-Thro Deluxe 24 Service Manual

Install Bottom Cover

1. Reinstall bottom cover and secure with two tapping
screws and four hex bolts.
2. Return unit to operating position.
Figure 17
ATTACHMENT DRIVE BELT
REPLACEMENT

Remove Attachment Drive Belts

IMPORTANT: Save all hardware for reinstallation.
1. Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2. Disconnect spark plug wire from engine.
3. Remove auger housing. See Separate Housing From
Frame on page 7.
4. Remove attachment drive belts from attachment drive
pulley. See Figure 18.

Install Attachment Drive Belts

1. Install belts onto attachment drive pulley.
2. Reinstall auger housing to frame. See Reinstall Auger
Housing on page 10.
EN – 13
Figure 18