Install Bottom Cover
1.
Reinstall bottom cover and secure with six hex bolts.
2.
Return unit to operating position and support
handlebar. Ensure that unit is secure and will not tip.
CAUTION: AVOID ENGINE DAMAGE. Allow unit
to rest in operating position for 30 minutes before
starting engine.
3.
Reinstall brush attachment. See Install Brush to
Frame on page 9.
ATTACHMENT DRIVE BELT
REPLACEMENT
Remove Attachment Drive Belt
IMPORTANT: Save all hardware for reinstallation.
1.
Turn engine key to off position, remove key and close
fuel valve.
2.
Wait for all moving parts to stop and for hot parts to
cool.
3.
Disconnect spark plug wire.
4.
Separate brush from frame. See Separate Brush From
Frame on page 7.
5.
Remove attachment drive belt from attachment drive
pulley and discard. See Figure 12.
Install Attachment Drive Belt
1.
Install belt onto attachment drive pulley.
2.
Reinstall brush attachment. See Install Brush to
Frame on page 9.
3.
Adjust attachment drive clutch. Refer to Operator's
Manual for adjustment procedure.
IMPORTANT: Check all adjustments after first use.
EN – 11
Figure 12