6.
Reinstall transaxle bypass rod through unit rear and
into bypass arm on transaxle. Secure with hairpin. See
Figure 52.
Figure 52
See Figure 53.
7.
Align transaxle with transaxle mount.
8.
Reinstall two hex bolts through transaxle mount and
transaxle. Secure with two flat steel washers, two
locking washers and two hex nuts, but DO NOT
tighten hardware.
9.
Check chain tension and adjust if necessary. See
Check Chain Tension on page 28 and Adjust Chain
Tension on page 28.
10. Tighten hardware if chain tension is within
specification.
See Figure 54.
11. Reinstall hex bolt and locking nut securing front of
transaxle to transaxle bracket and tighten.
12. Adjust transaxle chain tension. See Adjust Chain
Tension on page 28.
13. Reinstall transaxle shroud and secure with tapping
screw.
EN – 27
Figure 53