Ariens Professional Sno-Thro Series Service Manual page 57

10. With a snap ring pliers, remove retaining ring. See
Figure 129.
See Figure 130.
11. With a driver, strike impeller shaft end until shaft is
through front of gearcase.
NOTICE: DO NOT strike impeller shaft end without using a
driver.
12. Remove pin and bushing from impeller shaft.
13. Remove impeller shaft from gearcase and remove all
loose parts from inside gearcase.
Figure 129
Figure 130
14. Remove seals and flange bushings from gearcase.
See Figure 131.
EN – 56
Figure 131