Ariens Professional Sno-Thro Series Service Manual page 15

Generation 3 Chute Control Design
See Figure 16.
18. Remove hairpin from clevis pin and reinstall cable
eyelet onto clevis pin.
19. Insert clevis pin through chute control bracket and
secure with hairpin.
Generation 2 Chute Control Design
20. Remove hairpin from chute control assembly and
reinstall cable eyelet onto assembly. Reinstall hairpin.
See Figure 17.
Generation 2 Chute Control Design
All Models
21. Reinstall gear cover and secure with tapping screw.
22. Reinstall chute deflector cable into J-clamp on engine
mount.
23. Reinstall deflector cable anchor into deflector bracket.
Generation 3 Chute
Control Design
Figure 16
Figure 17
24. Remove sleeve bushing and hairpin from deflector
arm and reinstall cable eyelet onto deflector arm.
Reinstall sleeve bushing and hairpin. See Figure 6.
25. Reconnect spark plug wire.
26. Adjust chute lock cable and deflector cable. Refer to
operator's manual for instructions.
IMPORTANT: Check all adjustments after first use.
WARNING: AVOID INJURY. Auger / impeller
must stop within 5 seconds when attachment
clutch lever is released.
EN – 14