External Devices; Printer - Welch Allyn Spot Vital Signs LXi Directions For Use Manual

46 Manual Entries and External Device Operation
2. Press the Navigation buttons to select the desired function and press the Select
button. Follow instructions on the display.

External Devices

You must enable each external device in the Internal Configuration Mode before using
it (see
as instructed in the Internal Configuration Mode.

Printer

Once the printer is enabled in the Internal Configuration Mode, you can use plain or label
paper. If you use label paper, you must clean the printer heads after every 10 rolls. A head
cleaner kit is provided with each package of label paper available from Welch Allyn.
To connect the printer to the Spot LXi:
1. Connect the the large end of the cable (405210) to the Spot LXi.
2. Connect the small end of the cable (405210) to the Spot LXi printer.
Connect to
Spot LXi
To charge the Spot LXi printer:
1. Remove the guard on the power supply body (713703 or BC1300M) and attach the
appropriate power supply plug/adapter.
2. Connect the Spot LXi printer power supply to the Spot LXi printer.
3. Charge the Spot LXi printer for at least 6 hours before initial use.
To enable the Spot LXi printer:
1. Connect the Spot LXi printer to the Spot LXi.
2. Enable the printer in the Internal Configuration Mode of the Spot LXi (see "Internal
Configuration" on page 31, and then see
To print the most recent reading:
1. Press the Memory button to recall the last reading.
Table 7 on page 34). Verify that each device is attached on the back of Spot LXi
Welch Allyn Spot Vital Signs LXi
Connect to
Spot LXi printer
Table 7 on page 34).