Welch Allyn Spot Vital Signs LXi Directions For Use Manual page 15

Directions for Use
WARNING Do not autoclave.
WARNING This device complies with current required standards for
electromagnetic interference and should not present problems to other
equipment or be affected by other devices. As a precaution, avoid using this
device in close proximity to other equipment.
WARNING Welch Allyn is not responsible for the integrity of any mounting
installation. Welch Allyn recommends that the customer contact their Biomedical
Engineering Department or maintenance service to ensure professional
installation for safety and reliability of any mounting accessory.
WARNING The Spot LXi consists of high-quality precision parts. Protect it from
severe impact and shock. A qualified service technician must check any Spot LXi
that is dropped or damaged for proper operation prior to further use. Do not use
the Spot LXi if you notice any signs of damage. Contact the Welch Allyn
Customer Service Department for assistance.
WARNING Do not use an SpO
simultaneously on the same limb. Doing so may result in inaccurate pulse rate
and perfusion readings.
WARNING All signal input and output (I/O) connectors are intended for
connection of only devices complying with IEC 60601-1, or other IEC standards
(for example, IEC 60950) as appropriate to the device. Connecting additional
devices to the Spot LXi may increase leakage currents. To maintain operator and
patient safety, it is necessary to consider the requirements of IEC 60601-1-1.
WARNING For proper patient electrical isolation, use only a Welch Allyn power
supply (4500-101A) to charge Spot Vital Signs LXi. Do not use the manufacturer
supplied charger for the weight scale while it is attached to Spot LXi.
NOTE: while charging the Spot LXi, it is acceptable to charge the Spot LXi
printer with the power supply (713703 or BC1300M).
finger clip sensor and a blood pressure cuff
2
Introduction 5