Selecting The Trigger Delay Application; Programming The Front Panel Display - Racal Instruments 1269 User Manual

Selecting The Trigger
Delay Application
Programming
Front Panel Display
Using The Enhanced Monitoring System 4-24
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The trigger delay may be placed between ONE of the following:
1) TRIG IN input to selected TTLTRG line
2) Selected TTLTRG line to TRIG OUT output
3) TRIG IN input to TRIG OUT output
4) Nothing (no delay)
The following commands may be used to select the delay
application:
VXI:CONF:MONITOR:TRIG:DELAY:STATE
VXI:CONF:MONITOR:TRIG:DELAY:STATE
VXI:CONF:MONITOR:TRIG:DELAY:STATE
The first command applies the delay between the TRIG IN
input and the selected TTLTRG line. The second command
places the delay between the selected TTLTRG line (or TRIG
IN input) and the TRIG OUT output.
removes any trigger delay from the trigger subsystem.
The present trigger delay application may be read using the
query:
VXI:CONF:MONITOR:TRIG:DELAY:STATE
The reply to this query will be one of the following:
INP
OUTP
NONE
The EMS has a 10 character LED display which is capable of
The
displaying all printable characters.
uppercase and lowercase "A" through "Z", the comma, single
quote, double quote, forward and backward slash, asterisk,
dollar sign, percent sign, and so on. A space character may
also be displayed.
At Power-On and after a reset command ("*RST"), the front
panel display is turned on. The front panel will display the
message:
Standby
if the AC line power switch is off. If the AC line power switch is
1269 User Manual
INPUT
OUTPUT
NONE
The third command
This includes both