Racal Instruments 1269 User Manual page 167

Error Message
0,"No Error"
-100,"Command error"
-101,"Invalid character"
-102,"Syntax error"
-103,"Invalid separator"
-104,"Data type error"
-105,"GET not allowed"
-108,"Parameter not allowed"
-109,"Missing parameter"
-110,"Command header error"
-111,"Header separator error"
-112,"Program menmonic too long"
-113,"Undefined header"
-114,"Header suffix out of range"
-120,"Numeric data error"
-121,"Invalid character in number"
-123,"Exponent too large"
-124,"Too many digits"
-128,"Numeric data not allowed"
-130,"Suffix error"
-131,"Invalid suffix"
-134,"Suffix too long"
-138,"Suffix not allowed"
-140,"Character data error"
-141,"Invalid character data"
Error Messages B-2
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Table B-1, Error Messages
ESR Bit Set
none The error queue is empty.
CME The command is not recognized.
CME There is an invalid character embedded in the command.
CME An unrecognized command or data type was encountered.
The parser was expecting a separator and encountered an
CME
illegal character.
The parser encountered a parameter data type different than
CME
expected. (For example, expected numeric/received string).
CME A Group Execute Trigger was received within a command.
CME More parameters were received than were expected.
CME Fewer parameters were received than expected.
CME An error was detected in the header.
CME An illegal separator character followed the command header.
CME The command keyword contains more than 12 characters.
CME Command header is syntactically correct but not recognized.
CME The value of a numeric suffix makes the header invalid
(VOLT8).
CME The data appears to be numeric but is syntactically incorrect.
CME An invalid character for the data byte was encountered.
CME The magnitude of the exponent was larger than 32000.
The mantissa of a decimal numer contains more than 255
CME
digits.
CME A legal numeric data element was received but is not allowed.
CME The command suffix is not understood or recognized.
The suffix does not follow the syntax in IEEE-488.2, Sec
CME
7.7.3.2.
CME The suffix contains more than 12 characters.
A suffix was encountered after a numeric parameter value
CME
where no suffix is allowed. (e.g." *SRE 255 MHZ").
CME A character received as a command parameter is invalid.
CME The character data element has an invalid character or the
character data is not valid for the command header.
1269 User Manual
Error Description