Putting The Filter In Place - Krups EA69 Series Manual

IFU_KR_COFFEEMAKER_EA69xx_0828344_EN 17/06/10 16:51 Page5

2.3 Putting the filter in place

!
Caution! To prime the cartridge correctly, follow this procedure every time you fit a cartridge.
n
When using later or replacing the cartridge: Select the "FILTER" function using the Prog but-
ton : : Maintenance -OK - Filter - OK - Place or change -OK - and follow the instructions
on the screen.
3
PREPARING THE APPLIANCE
Pull out and fill the water
tank.
!
Note: Do not fill the water tank with hot water, milk or any other liquid. If you turn on the appliance when the
water tank is not in place or not correctly filled (under the "min." level,), the "fill water tank" light will come on
and making an espresso or a cup of coffee will be made impossible.
! Caution! Never put ground coffee in the coffee container.
! Caution! It is recommended that you do not use oily, caramelised or flavoured coffee beans for this
machine. These kinds of beans may damage the machine.
! Caution! Check that the coffee beans do not contain any foreign particles such as grit, as any da-
mage caused by the presence of foreign particles will negate the guarantee.
Do not put water into the coffee bean container.
Remember to fit the drip tray to avoid waste water flowing onto the work surface and stai-
ning it or scalding you.
Check that your water tank is clean.
Installing the cartridge in the ma-
chine.
On first use, screw the filter car-
tridge into the bottom of the water
tank.
Put it back in place by
pressing firmly and close
the lid again.
Place a 0.5 L container
underneath the steam
nozzle.
Open the coffee bean
container lid. Add the coffee
beans (250g maximum).
ENGLISH
Close the coffee bean
container lid again.
5