Rinsing The Circuits - Krups EA69 Series Manual

IFU_KR_COFFEEMAKER_EA69xx_0828344_EN 17/06/10 16:51 Page6
KRUPS
SERIE EA69xx
3.1 First use / setting machine parameters
n
Use the rotating button to select a function, increase or reduce values.
n
Confirm your choice using the OK key.
Press to turn your
appliance on. Follow the
instructions that appear
on the "choice of language"
screen.
The appliance will ask you to set:

Language

Volume Unit

Date

Clock

Auto-off

Auto-on

Water Hardness
! Caution! When being used for the first time, it is possible that the machine will ask to be filled up. Just
follow the instructions on the screen.

3.2 Rinsing the circuits

Rinsing out the coffee circuit :
Once you have turned the machine on and the preheating stage has
completed, you can rinse out the coffee circuit.
Place a container under the coffee outlets then select "YES" from the
menu proposed. The rinsing cycle will stop automatically after about
40 ml.
n
Press at any time to display menus to perform rinsing and then select MAINTENANCE => OK
=> RINSING.
!
Note: It is best to perform rinsing after the appliance has remained unused for several days.
6
Use the rotating button to
choose a language (high-
lighted). Press the OK key
to validate.
You can select your chosen language from those offered.
Choose either ml or oz as your measurement unit.
You must set the date.
You can choose between 12 hour or 24 hour time display.
You can choose the period after which your appliance will stop automatically, from 30 minutes to 4
hours by 30 minute increments.
You can automatically start pre-heating of your appliance at your chosen time.
You must set your water hardness between 0 and 4. See "Water hardness measurement" section.
Select
When you first use your appliance, it will ask you to set several
parameters. If you unplug your appliance, you will again be
asked for some of these parameters.
Rinsing out the steam circuit :
Place a container under the steam nozzle. Press the
rinse the steam circuit. The rinsing cycle will stop automati-
cally after the volume of water displayed has flowed through.
Confirm
key to