Krups EA69 Series Manual page 18

IFU_KR_COFFEEMAKER_EA69xx_0828344_EN 17/06/10 16:52 Page16
KRUPS
SERIE EA69xx
The coffee is not creamy enough.
The appliance does not serve any
coffee.
You have used ground coffee
instead of coffee beans.
The grinder makes a strange noise.
The grinding fineness knob is hard to
turn.
The steam does not come out of the
nozzle.
There is not enough milk froth.
The milk froth is too bubbly.
The Auto-Cappuccino accessory
does not suck the milk (accessory
sold separately).
After filling the water tank, the
warning message is still displayed.
The cleaning or descaling programme
will not start.
16
Turn the grinding fineness knob towards the left for a finer grind
(may depend on the type of coffee used).
Change the Claris Aqua Filter System cartridge (follow the ins-
tallation procedure on page 3).
Carry out one or two rinsing cycles.
An incident has been detected during the preparation.
The appliance resets itself automatically and is then ready for a
new cycle.
Use your vacuum cleaner to suck out the pre-ground
coffee in the coffee bean tank.
There are foreign particles in the grinder.
Contact KRUPS Customer Service.
Only change the grinder setting when it is operating.
After switching off your appliance and leaving it to cool:
Make sure the tip of the steam nozzle is properly affixed. Make
sure the air inlet on the steam nozzle is not clogged at the ae-
rator (if necessary clean the air inlet with the needle supplied).
Empty the tank and remove the Claris filter. Fill the tank with mi-
neral water high in calcium (> 100 mg/litre or .015oz/gallon), it
may take as many as 5 to 10 cycles of steam at 60 seconds
each cycle to achieve a continuous jet of steam. Once you have
a continuous jet of steam you should not have to use this par-
ticular type of water again.
Using the needle supplied unblock the small air inlet at the top
of the nozzle if required.
Use a cold container and very fresh, very cold milk that has been
opened recently.
Try changing the type of milk if this does not work (UHT or pas-
teurised).
Check that the two ends of the small stainless steel tube are fit-
ted correctly into the flexible part of the steam nozzle.
Ensure that the tube immersed in the milk is not blocked.
Check that the flexible tube is not twisted and that it is
correctly fitted into the accessory to avoid any air being sucked in.
After switching of your appliance and leaving it to cool, unblock
the outlet of the Auto-Cappuccino accessory.
Check that the tank is fitted correctly onto the coffee
machine.
Check that the float at the bottom of the tank moves freely.
Rinse the tank and descale if necessary.
Unplug the appliance for 20 seconds then switch it back on.