2-Cup Function - Krups EA69 Series Manual

IFU_KR_COFFEEMAKER_EA69xx_0828344_EN 17/06/10 16:51 Page8
KRUPS
SERIE EA69xx
4.2 Making a coffee
n
The amount of water required for a coffee is between 80 and 160 ml.
4.3 Making a long coffee
n
The amount of water required for a long coffee is between 120 and 240 ml. The machine
automatically carries out a double cycle, do not remove your cup before the process has ended.
n
There is a temperature setting function to control how hot your coffee is (see § Settings).
!
Note: The ground coffee is first moistened using a little hot water after the grinding stage. A few moments later, per-
colation as such begins.
!
Caution! Do not remove the water compartment before the end of the cycle (that is around 15 seconds
after the coffee has finished dripping through).

4.4 2-cup function

n
Your appliance enables you to prepare 2 cups of coffee or espresso for the following 3 kinds of drink :
espresso / strong espresso / coffee. For "Large coffee" drinks, the 2-cup function is not
available. Remember not to remove the cups after the first cycle. You have now prepared your ap-
pliance. The drink select menu will be displayed.
o
Put two cups under the cof-
fee outlets.
You can lower or raise the
coffee outlets to suit the
size of your cups.
5
PREPARING HOT WATER
! Caution! To interrupt the steam function, just press any key.
If the nozzle is blocked, clean it out with a fine needle.
The maximum amount of hot water per cycle is limited to 300 ml.
8
Select your drink and confirm
by clicking twice on the OK
key. A message will appear to
tell you that you have chosen
two cups.
While the screen displays the drink selection menu, press the "hot water" key
A message will invite you to place a container under the steam nozzle. Again press the "hot water" key
produce hot water.
!
automatically sequence 2 complete
coffee making cycles.
X 2
Note: The appliance will
.
to