Barco B-16 Mobile LED Installation Manual page 41

6. Remove the third security pin.
Turn the pin a quarter turn and take it out.
7. Move down the display until the lower part matches the pins on the trolley.
The bottom tile locks must be closed while moving down the display.
Note: Watch out that cables are not under the display.
Image 4-4
Locking first part
8. Open the tile locks between the lower part and the middle part.
Note: If necessary, use the tile lock tool to open the locks.
Image 4-5
Open tile locks
9. Insert the sequence pin for 50%.
Image 4-6
Sequence pin half
1 Sequence pin
Note: Due to friction inside the mast, it is possible that the pin cannot be inserted. Move the mast a little bit up or down until it
is possible to insert the pin.
10.Lift up display until it becomes free from the second part (lift up maximum 15 cm).
Caution: Do not lift up more, otherwise the tile lock in the middle of the display (inside the tile guide) will be damaged
11. Close all tile locks.
R59770490 B-16 MOBILE LED 07/01/2010
4. Moving down the display
37