Retransfer Series Printers
Before You Begin
•
If your printer has locks, unlock the input hopper or printer access
door lock. If your printer does not have locks, disregard any
instructions that ask you to unlock the printer.
•
When you clean a printer using either the isopropanol or adhesive
cleaning card, we recommend that you remove both the ink ribbon
(C1) and retransfer film (C2) cartridges. If you are not authorized to do
so, disregard that portion of the instructions.
When using the isopropanol cleaning card:
• Between ribbon changes, removing the ink ribbon and
retransfer film cartridges is optional.
• If you change the ink ribbon, remove the supplies to clean
the printer.
•
Other procedures require you to remove only one of the
cartridges. Refer to the instructions for complete information.
Do the following to remove the supply cartridges if directed by the clean-
ing instructions.
1. Unlock the printer and open the printer access door.
2. Remove the ink ribbon and retransfer film cartridges.
3. Close and lock the printer access door, unless instructed
otherwise.
4. Continue with the cleaning procedure.
6
Use the Isopropanol Cleaning Card
Use the isopropanol cleaning card regularly to clean the printer.
Single-Hopper Printer
1. Remove the ink ribbon and retransfer film cartridges. Refer to
You Begin" on page
2. Unlock and open the input hopper.
3. Remove the unprinted cards. Handle
the cards by the edges or wear card
inspection gloves.
4. Open the cleaning card package and remove the
isopropanol cleaning card.
5. Load the cleaning card in the input hopper. Clean the printer imme-
diately. The cleaning card dries out if it is out of its package for more
than a few minutes.
If the cleaning card appears
bowed, insert it as shown.
Card Without Bow
Card With Bow
6. Close the input hopper and lock the printer.
7. Continue with
527983-001_B
527983-001_B
Cleaning Guide
6.
"Run the Isopropanol Cleaning Card" on page
"Before
Isopropanol
Cleaning Card
9.
7
Need help?
Do you have a question about the Retransfer Series and is the answer not in the manual?