Clean The Rear Fan Filter; Card Handling Information - Entrust Datacard Retransfer Series Cleaning Manual

Retransfer Series Printers

Clean the Rear Fan Filter

The rear fan filter is not present in all printer models.
If your printer includes a rear fan filter, clean the filter every three months.
1. Unlock the printer and open the printer access door.
2. Press the K3 rear access door release to open the rear access door.
3. Lift up and remove the filter from the fan mount.
4. Rinse the filter under running water and shake it gently to remove
excess liquid. Pat it with a paper towel to remove additional water.
5. Allow the filter to dry completely.
6. Insert the filter into the fan mount.
7. Close the rear access door.
8. Close the printer access door and lock the printer.
20

Card Handling Information

Use the following information when purchasing and handling card stock:
• Purchase quality card stock. Excessive burrs, scratches, surface
defects, or contaminates on cards can result in print errors.
• Grease or oils, such as oils from your fingers, can reduce card quality.
To keep cards completely clean, do not touch the print surface of a
card.
• Handle blank card stock by the edges only, or wear the card inspection
gloves included in the cleaning kit.
• Debris or particles on blank card stock can reduce card quality and
Rear Fan
damage the system. If you drop a card on the floor, clean it using a
Filter
lint-free cloth before using it in the system. Do not use solvents to
clean the card.
• Avoid contact with the following, as they can cause discoloration or
fading of the cards:
ƒ
ƒ
ƒ
• Avoid storing the cards in locations exposed to direct sunlight, or with
high temperature and high humidity.
527983-001_B 527983-001_B
Organic solvents, such as alcohol, film cleaner, or diazo paper.
Soft vinyl chlorides, document cases, pass holders, or erasers.
Hand lotions, hairdressing products, or cosmetics.
Cleaning Guide
21