Table of Contents
Advertisement
Chapter 4: AMI BIOS
NVMe Firmware Source
This feature controls the NVMe firmware source, between AMI native
support or vendor defined firmware. The default is Vendor Defined
Firmware.
PCH SLOT4 PCI-E 3.0 X1 OPROM
PCH SLOT5 PCI-E 3.0 X1 OPROM
PCH SLOT6 PCI-E 3.0 X1 OPROM
CPU SLOT7 PCI-E 3.0 X16 OPROM
Select Disabled to deactivate the selected slot, Legacy to activate the
slot in legacy mode and EFI to activate the slot in EFI mode. The options
are Disabled, Legacy, and EFI.
Onboard LAN Option ROM type
Use this feature to select the type of option ROM installed. The options
are EFI and Legacy.
Network Stack
Select Enabled to enable PXE (Preboot Execution Environment) or UEFI
(Unified Extensible Firmware Interface) for network stack support. The
options are Disabled and Enabled.
*If this feature is enabled, the two features below are available.
Ipv4 PXE Support
Select Enabled to enable Ipv4 PXE (Preboot Execution Environment) for
boot support. If this feature is set to Disabled, Ipv4 PXE boot option will
not be supported. The options are Disabled and Enabled.
Ipv4 HTTP Support
Use this feature to enable IPv4 HTTP boot support. The options are
Disabled and Enabled.
Ipv6 PXE Support
Select Enabled to enable Ipv6 PXE (Preboot Execution Environment) for
boot support. If this feature is set to Disabled, Ipv6 PXE boot option will
not be supported. The options are Disabled and Enabled.
Ipv6 HTTP Support
Use this feature to enable IPv6 HTTP boot support. The options are
Disabled and Enabled.
4-19
Advertisement
Table of Contents
