Supermicro C7C242-CB-M User Manual page 67

Chapter 4: AMI BIOS
Wait for "F1" If Error
Use this feature to force the system to wait until the "F1" key is pressed
if an error occurs. The options are Disabled and Enabled.
Re-try Boot
If this feature is enabled, the BIOS will automatically reboot the system
from a specified boot device after its initial boot failure. The options are
Disabled, Legacy Boot, and EFI Boot.
Watch Dog Function
If enabled, the Watch Dog Timer will allow the system to reset or gen-
erate NMI based on jumper settings when it is expired for more than
5 minutes. The options are Disabled and Enabled.
AC Loss Policy Depend on
Use this feature to set the power state after a power outage. Select
Stay Off for the system power to remain off after a power loss. Se-
lect Power On for the system power to be turned on after a power
loss. Select Last State to allow the system to resume its last power
state before a power loss. The options are Stay Off, Power On,
and Last State.
Power Button Function
This feature controls how the system shuts down when the power but-
ton is pressed. Select 4 Seconds Override for the user to power off the
system after pressing and holding the power button for four seconds or
longer. Select Instant Off to instantly power off the system as soon as
the user presses the power button. The options are Instant Off and 4
Seconds Override.
EuP Support
This feature enables EuP support. The options are Disabled and Enabled.
DeepSx Power Policies
This feature enables DeepSx Mode configurations. The options are Dis-
abled and Enabled in S4-S5.
CPU Configuration

CPU Flex Ratio Override
This feature enables CPU Flex Ratio override programming. The options
are Disabled and Enabled.
4-5