Supermicro C7C242-CB-M User Manual page 78

Supermicro C7C242-CB-M/MW Motherboard User's Manual
Bits per second
This feature sets the transmission speed for a serial port used in Con-
sole Redirection. Make sure that the same speed is used in both host
computer and the client computer. A lower transmission speed may
be required for long and busy lines. The options are 9600, 19200,
57600, and 115200 (bits per second).
Flow Control
Use this feature to set the flow control for Console Redirection to pre-
vent data loss caused by buffer overflow. Send a "Stop" signal to stop
data sending when the receiving buffer is full. Send a "Start" signal
to start data sending when the receiving buffer is empty. The options
are None, Hardware RTS/CTS, and Software Xon/Xoff.
The setting for each these features is displayed:
Data Bits, Parity, Stop Bits
SATA and RSTe Configuration

SATA Controller(s)
This feature enables SATA device(s). The options are Disabled and En-
abled.
SATA Mode Selection
This feature controls the SATA mode. The options are AHCI and Intel
RST With Intel Optane System Acceleration.
SATA Frozen
This feature enables SATA freeze lock security support. The options are
Disabled and Enabled.
Aggressive LPM Support
This feature enables the PCH to aggressively enter link power state. The
options are Disabled and Enabled.
Storage Option ROM/UEFI Driver
This feature controls the execution of UEFI and Legacy Storage OpROM.
The options are Do not launch, UEFI, and Legacy.
4-16