Safety Information - Milton Roy MAXROY Series Actuator Capacity Control Manual

1 SAFETY INFORMATION

READ THESE INSTRUCTIONS CAREFULLY BEFORE USE
The following documents should also be consulted:
a) IEC/EN60079-14 standard (electric installations in gaseous
explosive atmosphere),
b) IEC/EN60079-17 standard (inspection and maintenance
operations in dangerous areas),
c) National Electrical Code (NEC500) for the USA and Canadian
Electrical Code (CEC500)
d) Decrees, ministerial orders, laws, directives, standards,
procedures and any other document relative to the area where
the actuator has to be installed.
Milton Roy, LLC cannot be judged responsible for the non-respect of
these rules.
Our equipment complies with the CSA and FM Standard and are
therefore CSA marked with indicators ''C" and ''US".
Our equipment complies with IECEx and ATEX Standard and are
therefore IECEx and ATEX marked.
They have been designed to be used in explosive atmospheres:

class I, group C, D in presence of vapor, fog or gas

class II, group E, F, G and class III for dust

group II - category 2 in presence of vapor, fog or gas (G).
Use in zone 1 or 2 for gas
Please check the compatibility between the indications written on the
identification plate and the explosive atmosphere type, the ambient
and the admissible surface temperature of the installation area.
The actuator installation and maintenance must be carried out by
qualified, trained and certified personnel.
Please carefully read this whole document before mounting and
starting-up the actuator.
/
English
Page 4 of 33