Mechanical Stops Settings (Acc-3/4T Only); Cams Settings - Milton Roy MAXROY Series Actuator Capacity Control Manual

12 MECHANICAL STOPS SETTINGS (ACC-3/4T ONLY)

!
Only for ACC-3/4T
Mechanical stops are set for an electrical travel of 270±3°.
Mechanical stops are factory set. Their setting does not

require to be resumed.
They must not be used as travel limits.

12.1 Cams settings.

The cam rotates as the
output shaft and triggers a
switch by pushing on its
lever.
Cams orientation are factory
pre-set, yet you can still re-
adjust them
installation if necessary.
Rep.
1
2 Counter-clockwise travel limit
3
4 Counter-clockwise signaling
upon the
Function
Clockwise travel limit
Clockwise signaling
Table 10 : Cam function
Page 27 of 33
/
English
Figure 12. Adjustment to 0% flow (ACC 3/4 Only)
Status before installation
Pre-wired, cam pre-set
Pre-wired, cam pre-set
To wire, to set
To wire, to set