Elektron MULTIMIG 200 Operation Manual page 19

Fig. 26: safety question
Select „YES" for overwriting the job by
turning operation knob 52.
Confirm „YES" by pressing operation knob
52.
Fig. 27: Save job
If required the job name can be changed.
(see „edit job ext).
Save the job by pressing key 51.
Press key 46, 50 or 51 to exit menu and
return to standard display.
Edit Job-text
Press key Tiptronic 50.
Set menu option „edit job text" by turning
operation knob 52.
Confirm menu option „edit job text" by
pressing operation knob 52.
Select the job no. where text must be edited
by turning operation knob 52.
Confirm the job no. by pressing operation
knob 52.
Fig. 28: edit job text
Press key mode 47 to edit numbers.
Press key secondary parameter 46 to edit
letters.
Repress key secondary parameter to
change between capital and small letters.
Set the required number or letter by turning
operation knob 52.
Confirm number or letter by pressing op-
eration knob 52.
Repeat above procedure for each character.
Use key Tiptronic 50 to go back stepwise in
order to correct a character.
Press key secondary parameter 51 to fi-
nalize the saving process.
Press key 46, 50 or 51 to exit menu and
return to standard display.
Select job
Press key Tiptronic 50.
Set menu option „select job" by turning
operation knob 52.
Confirm menu option „select job" by press-
ing operation knob 52.
A listing of all existing jobs will be displayed
in the menu. The currently selected job is
marked with a tick (√) on the right side.
MULTIMIG 200
Start-up
19