Table of Contents
Advertisement
7
Ambient conditions
Temperature range of ambient air:
In operation:
-10 °C ... +40 °C (+14 °F ... +104 °F)
Transport and storage:
-25 °C ... +55 °C (-13 °F ... +131 °F)
Relative humidity:
up to 50 % at 40 °C (104 °F)
up to 90 % at 20 °C (68 °F)
-25 °C ... +55 °C (-13 °F ... +131 °F)
Operation, storage and transport
may only be carries out within the
ranges indicated! Use outside of
this range is considered not used
with its intended purpose. The
manufacturer is not liable for dam-
ages cause by misuse.
Ambient air must be free of dust, acids, cor-
rosive gases or other damaging substances!
8
UVV inspection
Operators of commercially-operated welding
systems are obliged to have safety inspections
of the equipment carried out regularly in
accordance with VDE 0544-4. ELEKTRON
recommends inspection intervals of 12 months.
A safety inspection must also be carried out
after alterations or repair of the system.
Improper
destroy the system.
UVV
inspections
Electromagnetic compatibility (EMC)
9
Electromagnetic compatibility
(EMC)
This product is manufactured in conformance
with the current EMC standard. Please note
the following:
The machine is intended for welding in both
commercial
(CISPR 11
surroundings (for example in residential
areas) may disturb other electronic devices.
Electromagnetic problems during start-up
can arise in:
• Mains cables, control cables, signal and
telecommunication lines near the welding or
cutting area
• TVs / radios
• Computers and other control equipment
• Protection
systems
• Pacemakers and hearing aids
• Equipment for measurement and calibration
• Equipment with too little protection against
disturbances
If other equipment is disturbed it may be
necessary to provide additional shielding.
The affected area can be bigger than your
premises/property. This depends on the
building, etc.
Please use the machine in compliance with the
can
manufacturer's
operator is responsible for installation and use
of the machine. Furthermore, the owner is
responsible for eliminating the disturbances
caused by electromagnetic fields.
MULTIMIG 200
and
industrial
applications
class A).
Use
equipment
such
as
instructions.
The
in
other
alarm
machine
7
Advertisement
Table of Contents
Need help?
Do you have a question about the MULTIMIG 200 and is the answer not in the manual?
Questions and answers