Mitsubishi Electric a2 Series Programming Manual page 84

α
2 Simple Application Controllers
2 ) Press the "OK" key with the cursor in the function block. The function block edit screen is
displayed as shown
3 ) Highlight "Setup FB" and press "OK".
4 ) Highlight "InputVal" and press "OK".
5 ) If a constant output voltage is required, highlight "DirectSet" and press "OK." If not, skip to
step 7.
6 ) Enter a Direct Set value using the "+ and -" keys and press the "OK" key to accept the
value. Skip to Step 11.
7 ) If an analog input will be used, highlight "AnalogIn" and press "OK." If not, skip to step 9.
8 ) Select the appropriate analog input and press "OK. Skip to Step 11."
9 ) If an FB word output will be used as the input value for the Analog Output FB, highlight "FB
Value" and press "OK." If not, skip to step 11.
Function Blocks 6
B 0 0 1 : CN
S e t u p F B
C h a n g e N o
D e l e t e F B
B 0 0 1 : AO
I n p u t V a l
C h a n n e l
B 0 0 1 : AO
D i r e c t S e t
A n a l o g I n
F B V a l u e
B 0 0 1 : AO
A n a l o g O u t
D i r e c t S e t
0
B 0 0 1 : AO
I n p u t V a l
C h a n n e l
B 0 0 1 : AO
A n a l o g O u t
A n a l o g I n
A 0 1 0
B 0 0 1 : AO
I n p u t V a l
C h a n n e l
B 0 0 1 : AO
A n a l o g O u t
C o u n t e r
B 0 0 2
6 - 30