Mitsubishi Electric a2 Series Programming Manual page 137

α
2 Simple Application Controllers
Enter the PIN Code
It is necessary to enter a PIN code received from the Service Provider
α
2 controller is used to send SMS packets. Use the "+" and
when the
"-" keys to choose the digits of the code and the " " and " " keys to
move to adjoining digits. All the numbers must be set to an integer
value or a PIN Code Error will be received. Press the "OK" or "ESC" keys to return to the PIN
Code entry display. Finish entering all integer values into all four digits and press the "OK" key
to enter the code.
Cancel the PIN Code
To Cancel an existing PIN code, enter the PIN Code option and confirm
with the "OK" key the intent to Cancel the code. The PIN Code does
not have to be entered in order to Cancel the code. Use the "ESC" key
to return to the GSM menu.
Set SMS (Short Message Service) Parameters
The SMS menu is used to set the telephone numbers for the Service
Provider, the destination numbers for cellular phones, the access code
for e-mail messages, and the Validity Period of the messages.
The SMS Service Provider Mobile Access Number (SMSC1)
The SMSC1 is the number used to access the Service Provider section
for mobile phones. Choose the digits and symbols using the " " and
" " keys. After the digit is set, move to the left or right with the " " and
" " keys. Do not press the "OK" key until the command has been
entered in its entirety.
The SMS Service Provider Gateway Access Number (SMSC2)
The SMSC2 is the number used to access the E-mail gateway
telephone number of the SMS Service Provider. Choose the digits and
symbols using the " " and " " keys. After the digit is set, move to the
left or right with the " " and " " keys. Do not press the "OK" key until
the command has been entered in its entirety. This number may be the same as used in
SMSC1.
Destination Address (DA1, DA2, DA3)
Enter the destination mobile telephone number or the Service Provider
e-mail gateway code on this screen. Choose the digits and symbols
using the " " and " " keys. After the digit is set, move to the left or
right with the " " and " " keys. Do not press the "OK" key until the
command has been entered in its entirety.
Three destination mobile telephone numbers can be entered, one in each DA address.
Alternately, two mobile phone numbers and one e-mail gateway access code can be entered.
Only one e-mail access code needs to be entered and then multiple e-mail addresses can be
input, one each per GSM/SMS Function Block.
Function Blocks 6
P I N C o e d
S e t u p
[ ∗ ∗ ∗ ∗ ]
P I N C o d e
C a n c e l
E S C
O K o r
S e t SM S
SMS 1 C
SMS 2 C
DA 1
DA 2
DA 3
V P
S e t SM S 0 1
SMS 1 C
[ ]
9 + - ( ) 0 1 2 3
S e t SMS 0 1
SMSC 2
[ ]
9 + - ( ) 0 1 2 3
S e t SMS 0 1
DA 1
[ ]
9 + - ( ) 0 1 2 3
6 - 83