Table of Contents
Advertisement
CAUTION
FOR INSTALLATION IN CANADA THE INSTALLATION MUST BE
IN ACCORDANCE WITH CAN/CGA-B149.1&2 OF THE
INSTALLATION CODE, AND LOCAL CODES WHERE
APPLICABLE. ALL ELECTRIC WIRING MUST BE IN
ACCORDANCE WITH THE CURRENT CANADIAN ELECTRICAL
CODE, C22.1 PART 1. GROUNDING THIS APPLIANCE MUST
CONFORM TO CANADIAN ELECTRICAL CODE, CSA C22.2.
INSTALLATION OF THE UNIT MUST BE DONE BY PERSONNEL
WARNING
QUALIFIED TO WORK WITH ELECTRICITY AND PLUMBING
IMPROPER INSTALLATION CAN CAUSE INJURY TO
PERSONNEL AND /OR DAMAGE TO EQUIPMENT. UNIT MUST
BE INSTALLED N ACCORDANCE WITH ALL APPLICABLE
CODES.
DO NOT ALLOW ANY PART OF YOUR BODY TO BE UNDER THE
WARNING
OVEN DURING THE LIFTING PROCESS. KEEP EVERYONE
CLEAR FORM THE OVEN IF IT SHOULD FALL
Raising:
Raise the oven to its vertical, upright position with the use of a forklift or other lifting device.
Provide a means to lower the oven to the floor without dropping.
•
Secure two 5,000 lb. lifting straps to the rear lifting eyes on top of the oven and to a point on the
forklift 40 inches from the mast.
•
Secure a third 5,000 lb. strap to the front lifting eye on top of the oven and to the carriage of the
forklift. This strap should be situated so that it will prevent the oven from falling forward when it is
near upright.
•
Raise the forks and slowly move forward, keeping the lifting straps vertical. Slowly move forward
until the oven is upright.
•
Remove all straps and lifting equipment.
Raise the front of the oven with a pry bar and attach the front wheel assembly (located in the hood crate)
to the left front door jamb using #¼-20 truss-head screws provided.
Rotate the rear leveling adjusters clockwise until the rear wheels have extended and allow the rear of the
oven to roll.
ETL File 3028821
INSTALLATION CONT'D
.
10
Rev. A 2002
Advertisement
Table of Contents
