JUKI DU-1481 Series Instruction Manual page 25

Parameter Description of parame-
code ter
Correction to the over-
035.BT5
lapped stitching 5
Correction to the over-
036.BT6
lapped stitching 6
Selection of the con-
037. SMP stant-dimension sewing
mode
Pedal curve select func-
038.PM
tion
Reverse feed stitching
039.PS button compensation
stitching function
Setting of the thread
040.WON wiping / thread clamping
output function
Setting of statistics of
041.TM the number of pieces /
bobbin thread counts
Selection of the press-
er foot lifting opera-
042.FSM tion when the sewing
machine stops in the
middle of sewing
Selection of the press-
043.FTM er foot lifting operation
after thread trimming
Display of the number
044.PN of completed pieces of
product
Setting of enable / dis-
045.SS
able of soft start
Initial
Range Explanation of the content represented by the value
value
BT5, BT6 = 0, disabled
6
BT5, BT6 = 1 - 16, operation timing is advanced (in
increments of 1/8 stitches)
0 to 999
BT5, BT6 = 17 - 31, operation timing is retarded (in
5
increments of 1/8 stitches)
BT5, BT6 = 32 to 999 Not used
A: The sewing machine automatically performs the
constant-dimension sewing operation when the pedal
is lightly depressed
A/M A
M: It is possible to select start or stop of the sewing
machine as desired depending on the depressing
depth of the pedal.
0 - 9: The sewing machine runs at a low speed at the
beginning of sewing, then it changes the speed to a
high speed.
0 to 30 10 10 (medium value): No change in sewing speed
11 - 30: The sewing machine runs at a high speed at
the beginning of sewing, then it changes the speed to
a low speed.
It is enabled only in the case [011.RVM] is set to OFF.
0: Compensation stitching is not carried out with the
0 / 1 0 reverse feed stitching button
1: Compensation stitching is carried out with the re-
verse feed stitching button
0: Neither the thread wiping operation nor the thread
clamping operation are carried out
1: The thread wiping operation is carried out, and the
thread clamping operation is not carried out
2: The thread wiping operation is not carried out, and
0 to 6 2 the thread clamping operation is carried out.
3: Both the thread wiping operation and the thread
clamping operation are carried out.
4 to 6: Not used
Setting of the wiper operation: [071.W1] [072.W2]
Setting of the thread clamp operation: [067.T1] [068.T2]
0: Number of pieces count mode; the counter counts
up when the number of sewn pieces of product.
Other than 0: Bobbin thread count mode; the set value
of [021.CS] counts down according to the number of
0 to 100 0 stitches.
(Example)
1: Counting down by one for every stitch
10: Counting down by one for every 10 stitches
100: Counting down by one for every 100 stitches
OFF: The presser foot does not go up
OFF/ON OFF
ON: Presser foot goes up.
OFF: The presser foot does not go up.
OFF/ON OFF
ON: Presser foot goes up.
0 to 9999 0 Enabled when [041.TM] is set to 0 (zero).
OFF: Soft starting function is placed in OFF
OFF/ON OFF
ON: Soft starting function is placed in ON
– 23 –