JUKI DU-1481 Series Instruction Manual page 12

❻
❼
❾
Throat
plate
Small
Large

❼
❽
6 mm

– 10 –
3. Adjusting the amount of lift of the presser
foot
1) Loosen presser spring regulator ❻ and bracket
fixing screw ❼ .
2) Lift the presser foot by means of presser foot
lifting lever ❽ . Adjust bracket fixing screw ❼
up and down until presser foot ❾ is positioned
6 mm above the throat plate.
3) After the completion of adjustment, secure-
ly tighten bracket fixing screw ❼ and adjust
presser spring regulator ❻ appropriately.
4. Adjusting the feed amount of walking foot
Normally, the ratio of feed amount between
the feed dog and walking foot is 1:1. The feed
amount of walking foot can be adjusted accord-
ing to the sewing condition to be used.
1) Loosen nut  .
2) Adjust the installed position of vertical move-
ment control shaft  . The feed amount of
walking foot is decreased by moving vertical
movement control shaft  upward. The feed
amount of walking foot is increased by moving
vertical movement control shaft  downward.
3) After the completion of adjustment, tighten nut
 .