Cross Communication (Party Mode) - Datavideo ITC-300 Instruction Manual

2. When the operator of the base unit talks, all paired beltpacks will be able to hear
him at the same time. However, carrier of each individual beltpack will not be able
to hear communications of other channels. For example, beltpack 1 will not be
able to hear the communication between beltpack 4 and the base unit.
3. To cancel all communication, simply press the ALL button on the base unit's front
panel again, then the ALL button should turn green from red, and the channel
buttons should turn white from red.

Cross Communication (Party Mode)

In GROUP and ALL Communication modes, only the base unit is allowed to establish
communication with the beltpacks and the beltpacks will be refrained from
communicating with other channels. To allow the beltpacks to communicate with
other channels, you will need to enable the PARTY mode.
1. First enter GROUP or ALL communication mode. In this section, the party mode is
illustrated along with the ALL communication mode.
2. Press and hold the SHIFT button on the base unit's front panel,
then press Channel 2 button. The PARTY mode is enabled as soon
as Channel 2 button turns from green to red.
3. To disable the PARTY mode, press and hold the SHIFT button on the base unit's
front panel then press Channel 2 button. The PARTY mode is disabled as soon as
Channel 2 button turns green from red.
4. To check if the PARTY mode is enabled, press and hold the SHIFT button on the
base unit's front panel. Channel 2 button will be illuminated red if the PARTY
mode is enabled and green if the PARTY mode is disabled.
5. To adjust the PARTY mode's volume, first make sure the PARTY mode is enabled.
6. Press and hold the SHIFT button then press Channel 3 button to
increase the PARTY mode's volume and Channel 7 button to
decrease the party mode's volume. For each button push, the
volume increases or decreases by 3 dB.
7. Please note that when Channel 3 or 7 button becomes illuminated
in yellow, it means that the PARTY mode's volume has reached the
minimum or maximum.
20